Safety operation rules of hook type shot blasting machine

Safety operation rules of hook type shot blasting machine

1. The operation of the hook type shot blasting machine must strictly implement the special machine training and be familiar with the performance and characteristics of the machine.

2. Familiar with the operation procedures, use, repair and maintenance in this equipment manual.

3. Non-operating personnel shall not operate or touch the electrical switch control area at will to avoid accidents.

4. Operators must achieve civilized production and safe production while strictly implementing the handover system.

5. At the end of the work, immediately cut off the power switch of the machine to avoid running the equipment.

The above are the steps that the operator must do to operate the hook type shot blasting machine. It is hoped that the majority of operators should strictly keep in mind.

Working procedure of hook type shot blasting machine

After the preparation of the hook type shot blasting machine (dust removal system, hoist, screw conveyor, etc.) is completed, the machine starts to work normally. First, the hook lowers and lifts the work piece, rises to a certain position, and then enters the shot blasting cleaning room along the track. When it reaches the predetermined position, it stops and starts to rotate. At this time, close the door of the shot blasting room, open the shot blasting device, open the shot blast gate, and start the shot blasting of the workpiece. Repeat this process until the work is completed and stop in order.