Whether The Sandblasting Machine Should Be Debugged Before Use

After we bought the sandblasting machine, can we use it immediately? The answer is no, because it can only be officially put into use after debugging, and debugging is very important. If the debugging is not good, then there will be problems during the use of the sandblasting machine. Then we will elaborate on this content , The specific content is as follows.
Power-on test: first turn on the power switch on the electrical box. At this time, the power indicator should be on, and the lighting lamp in the blasting cabin should be on, and then start the fan. After the test, press the stop button, the fan should stop running.
Spray gun ventilation test: close the blast door, and then connect the compressed air, press the manual or automatic button, then the corresponding indicator light should be on, then the spray gun should spray a continuous and stable air flow.

Add abrasive: put the abrasive into the engine room, the quantity is 100 kg, as long as the abrasive is poured on the mesh plate, it will enter the separator through the circulation system, cannot be added in excess, and the added abrasive must be dry and pure, otherwise Will affect the cycle. Sandblasting test: After the above three operations, if there is no problem, then you can carry out sandblasting operation. Start the switch and let the sandblasting mechanism perform sandblasting on the workpiece to check for abnormalities.
I hope that through the above explanations, we can let everyone know how to debug the sandblasting machine, so that they can use the sandblasting machine, and I hope it will be helpful to everyone.