The Azimuth Angle Of The Shot Blasting Machine Should Be Adjusted In Time

       The product quality cleaning after the shot blasting machine is installed is very important. If the viewpoint is not adjusted properly, the desired cleaning effect will not be achieved and the product will be damaged.

       The projection angle of the shot blasting machine should be observed and adjusted in time. The shot blasting machine provides a special rule that can freely control its direction within the scale. Shot blasting machine uses high-speed projectiles thrown by the shot blasting machine to clean or strengthen the casting surface of casting equipment. The shot blasting machine can simultaneously shake out, remove the core and clean the castings. In some areas, it is also called sand blasting machine or sand blasting machine verbally. A processing technology in which steel grit and steel shots are shot and impacted on the surface of a material object at a high speed through a shot blaster. Compared with other surface treatment technologies, it is faster, more effective, and can be partially retained or the casting process after stamping. Crawler shot blasting machine high-strength wear-resistant rubber crawler or manganese steel crawler loading workpiece. It uses a high-speed rotating impeller to throw projectiles onto the workpiece in the chamber to achieve the purpose of cleaning. It is suitable for sand removal, rust removal, scale removal and surface strengthening of small castings, forgings, stamping parts, gears, springs, etc. It is especially suitable for cleaning and strengthening parts that are not afraid of collisions. After the cast, it will be on the top of the metal plate. It is very good to see whether the bullet point is left or right not in the corner or the center of the 90 degree angle. It should be adjusted in time if it exceeds this scale. As long as the rationality of the viewpoint adjustment can appropriately increase the speed of the projectile, the shot blasting machine can run smoothly and achieve excellent mechanical performance. If the adjustment is completed, it will show an error, adjust the spacing and viewpoint of the fasteners of the swing arm until it reaches a very good viewpoint so far.

        The structure of the shot blasting machine is very complicated. If it is used improperly, it will cause damage to the machine. So it is necessary to clearly know how to use the machine safely and standardly. First of all, it is necessary to maintain and maintain it, and secondly, some parts should be replaced regularly. If the above points are achieved, the machine can be used continuously, otherwise its service life will be greatly reduced.

         The shot blasting machine is the main part of the shot blasting machine. The correct orientation of the shot blasting machine directly affects the normal operation of the shot blasting machine, which requires the adjustment of the shot blasting machine. The pass-through shot blasting machine can work continuously and uninterruptedly, deoxidizing, cleaning and pre-treating various steel materials, such as steel plates, steel materials, steel beams, section steels, steel pipes and steel castings, in a continuous pass way. The operation is simple, just load the steel material on the machine, press the start button, after a short cycle, the system will automatically unload the processed material, that is, the entire cleaning process is completed, and all dust and residual pellets are removed. material. The adjustment of the shot blaster should pay attention to the orientation of the directional blasting. The workpiece should be cleaned so that the projectile is fully covered, otherwise the cleaning power will be affected.

         Orientation window position, if necessary, you can paint black ink or lay a piece of wood on a thick paper, place it in the direction of cleaning the workpiece, start the blasting device and the artificial shot blasting equipment into the shot tube to participate in a small number of projectiles, the direction of the projectile, If the blood positioning error, the direction should be adjusted to obtain the desired position. Excellent direction adjustment, can be used for load test, 30 minutes after blasting, and then participate in 400kg projectile.