Safe Use Of Shot Blasting Machine And Solving Oil Leakage

Safe use of shot blasting machine and solving oil leakage

How to deal with the oil leakage problem of the shot blasting machine, and the safety instructions on the operation and use of the equipment, these are very important knowledge contents for the mechanical equipment such as the shot blasting machine.

1. Cause analysis and solution of oil leakage of shot blasting machine

On this issue, Xinghua, a manufacturer of shot blasting machines, believes that there are three reasons, and there are corresponding solutions.

Reason one: The friction between the shaft and the hole is too large, which causes serious wear and tear, which leads to oil leakage problems. If you want to solve it, you can install a sealing rubber ring to avoid excessive wear.

Reason two: The oil leakage of the switch of the shot blasting machine may be due to wear or rust of the valve. At this time, the new one should be replaced in time, and some preventive measures should be taken to avoid corrosion.

Reason three: The seal is damaged, or the fastener is loose. For these two, the solution is very simple, is to replace the seal and tighten the fastener.

2. Safety instructions for the operation of the shot blasting machine

This aspect of equipment, in the view of Xinghua, a manufacturer of shot blasting machines, mainly includes:

(1) The operator must wear labor protection equipment before being able to work, otherwise it is strictly forbidden to work.

(2) For the dust removal equipment, it should be periodically opened to remove clean dust, etc. Moreover, when the equipment is shut down, the operation of the dust removal equipment cannot be stopped immediately.

(3) The control switch in the shot blasting machine cannot be turned on and off frequently, because this will cause excessive current and damage some instrumentation devices in the equipment.