How To Seal And Safe The Cleaning Room Of Shot Blasting Machine

How to seal and safe the cleaning room of shot blasting machine

As for the shot blasting machine, it can be said that we have a lot of knowledge and understanding of this product, but unfortunately, so far, it has not reached this level of comprehensiveness and specificity. Therefore, their study work must continue and cannot be stopped. Otherwise, it will not only make our study halfway, but also make everyone's understanding insufficient, and then make mistakes, etc., causing unnecessary problems or troubles.

1. Safety aspects of shot blasting machine

The debris scattered around the shot blasting machine should be removed in time. Moreover, for this machine and equipment, the workers should be kept away when working, and at least there should be a safe distance to avoid the equipment and parts hurting people. In addition, the maintenance of the shot blasting machine should be carried out when the equipment is powered off, and there are warning signs to avoid misoperation by other personnel.

2. Sealing of the cleaning chamber in the shot blasting machine

The cleaning room in the shot blasting machine is an important part. Therefore, there should be no problems in terms of sealing. So, how should it be done?

For the door of the cleaning room, manual folio should be used. And on the inside of the gate, it should be lined with wear-resistant rubber guards, the thickness is 5mm. Moreover, sponge rubber sealing strips should be pasted around the gate in order to have a good sealing effect. In addition, a baffle plate should be installed in the middle of the two doors to prevent the projectiles from flying out of the clean room. Below the gate, a pill-receiving trough is provided so that the projectile can be recovered and reused.

3. Shot blasting in the shot blasting machine

For the shot blasting machine, its main function is to remove the rust for the shot blasting, which is a mechanical method to achieve the purpose of removing rust through the blasting of the abrasive. In addition, it has the advantages of low cost and low pollution, which can be automated. However, it can only be performed indoors, not outdoors.