How To Adjust The Shot Blasting Device Of The Through Shot Blasting Machine

       The through-type blasting machine relies on the shot blasting device to accurately project the surface of the workpiece at high speed, remove the rust and dirt on the surface of the workpiece, strengthen the internal molecules of the workpiece, and make the internal molecules of the workpiece more closely arranged, thereby making the mechanical properties of the workpiece more Strong.

       It should be known that the projectile shot by the through-type shot blasting machine mainly relies on the shot blasting machine, and the long-term high-speed ejection of the shot blasting machine, due to the force, the ejection position will also be poor, and this situation must be shot blasting. Adjustment. And how to adjust the shot blasting device? Many are not understood, in fact, the method is very simple, that is, adjust the position of the directional sleeve, so that all the projectiles should fall on the workpiece being processed. Check whether the position of the adjusted directional sleeve is accurate. You only need to use a wooden board or white paper to replace the workpiece to be cleaned. Start the shot blaster, input a small amount of shot material, check the position of the projection belt, and finally adjust the position of the directional sleeve to Right location.

       It should be noted that after the directional sleeve of the pass-through shot blasting machine is adjusted, the load test can be carried out. It is necessary to make sure that the equipment is in good operation. After half an hour of shot blasting, the shot material is added, so that the equipment can be shot. The pill cleaning efficiency is higher and the effect is better. If you are not sure about the skills of the shot blaster adjustment, you can also consult the technicians of the equipment manufacturer.