Process issues that need to be paid attention to when building a sandblasting room

When building a sandblasting room, it is necessary to pay more attention to the process of the sandblasting room. With the continuous progress of society, people have higher and higher requirements for product coating, and the choice of sandblasting process of sandblasting machine manufacturers has gradually become inevitable. To build a sandblasting room, because it is necessary to solve the problems of dust control and abrasive recovery at the same time, it often requires a large investment. Based on the long-term experience with users in practice, we make the following process suggestions for your reference.

1. The maximum size of the workpiece must be planned. If the blasting room is too small, it is not conducive to the operation of large workpieces. If the blasting room is too large, the investment in the corresponding dust removal equipment, recycling equipment and civil engineering will increase, which will bring investment Unnecessary waste.

2. The output must be planned. The output is large and the tasks of the workers are full. It is necessary to build automatic recycling equipment for the whole room to improve efficiency; if the output is normal and the tasks are not balanced, the sandblasting machine manufacturer recommends partial automatic recycling plus manual auxiliary recycling. Way to save equipment and civil construction investment. After all, once a worker is hired, he cannot go to work if he has a task or take a break if he does not have a task. It should be normal to commute to and from work on time. After finishing the get off work in the morning, he will do the recycling work in the afternoon. When the task is busy, appropriate overtime is used to compensate.

3. Due to process requirements, some products (such as non-ferrous metals) must be made of glass sand, white corundum, and quartz sand. We suggest that it is better to use mechanical recycling to build a sandblasting room. Due to the high hardness of the above abrasives, the pipes, especially curved The head part wears very quickly. Although the use of honeycomb pneumatic recovery saves civil construction investment in the short term, there is also a lot of plugging and repair welding in the later stage. Regarding the degree of wear, the sandblasting machine manufacturer tells you that you can compare the working life of steel sand, steel shot and glass sand, white corundum, and quartz sand through the sandblast nozzle and the sandblast tube. If steel grit or steel shot is used, we recommend the honeycomb pneumatic recovery method.