Working principle of axle-through shot blasting machine

The round rod and tube shot blasting machine can work continuously and uninterruptedly. It can deoxidize, clean and pretreat various steel materials, such as steel pipes, round rods, shafts, etc. in a continuous way. The operation is simple, just load the steel material on the machine, press the start button, after a short cycle, the system will automatically unload the processed material, that is, the entire cleaning process is completed, and all dust and residual pellets are removed. material. During the cleaning process, the round rod and tube shot blasting machine is electrically controlled by the adjustable speed conveying V-shaped roller table to send steel pipes, round rods and shafts into the ejection zone of the cleaning machine room, inside the main body, V-shaped The rotation of the wheel drives the steel pipe to rotate, so that all sides of the body are hit and rubbed by powerful and dense projectiles from different coordinate directions, so that the oxide scale, rust layer and dirt on it will quickly fall off, and the surface of the steel will be smooth and clean with a certain roughness. On the surface, the workpiece is loaded and unloaded on the V-shaped roller table at both sides of the cleaning room. The projectiles and rust dust falling on the steel are blown by the blowing device, and the dropped pellet dust mixture is conveyed to the chamber funnel by the recovery screw, and the vertical and horizontal screw conveyors are collected in the lower part of the hoist, and then lifted to the upper part of the machine. In the container, the separated pure projectiles fall into the separator hopper for recycling use. Dust generated in shot blasting is sent to the dust removal system by the exhaust pipe, and the purified gas is discharged into the atmosphere, and the particulate dust is captured and collected.